Skip to content
Version 2026.25

P&ID Line ​

A simple P&ID schematic line, drawn as a polyline with optional arrowheads.

In Studio ​

Drawn with the pipe tool. On a view whose root is a Coordinate Container, choose the Draw / Edit Pipe Nodes tool on the toolbar, pick P&ID Line in the pipe-type menu beside it, then click on the canvas to place each corner. The same tool draws Pipe and Mimic Pipe; the menu decides which one the next line becomes.

When to use ​

Use P&ID Line for a schematic process-and-instrumentation line where a thin, uncolored connector is correct, rather than a two-tone pipe body.

Properties ​

PropertyTypeDefaultDescription
ThicknessNumber2The line's drawn thickness, in local canvas units (labeled "Thickness" in the Properties panel).
Line ColorColor#333333The line color.
Corner Styleround, miterroundHow the polyline's corners are drawn: round (default) or miter.
Start Arrownone, out, innoneArrowhead at the line's start vertex: none (default), out, or in.
End Arrownone, out, innoneArrowhead at the line's end vertex: none (default), out, or in.
Arrow SizeNumber12The arrowhead size, in local canvas units.
Quality Markstandard, dimstandardHow a lost link is marked when a value this component shows has Stale or Bad quality. standard (the default) draws the quality outline and glyph over the value. dim keeps the last good value on screen, faded, with nothing drawn over it: it suits a dense panel where one lost link turns a whole column Bad. The value still reads as not live, and a binding that fails to evaluate keeps its outline either way.

Binding ​

This component has no single value binding.